+- Mid-Atlantic 240SX Forums (http://forums.ma240sx.net)
+-- Forum: General (/forumdisplay.php?fid=1)
+--- Forum: Tech Talk (/forumdisplay.php?fid=3)
+--- Thread: Cheap White Bunny Install (/showthread.php?tid=3870)
Cheap White Bunny Install - miked808 - 08-02-2009 06:55 PM
I picked up a 1993 d21 Flywheel for $73 and a 1993 300zx N/A Clutch for $123 from NAPA. The clutch kit came with the correct pilot bearing and the release bearing even had the release fork installed so no need to press out the old one. I didn't have a pilot bearing puller so I packed the installed bearing with grease, took a 5/8 wooden dowel and gave a couple of whacks and it forces the grease behind the bearing and pushes it out. I also picked up the extra 3 pressure plate bolts size m8 1.25 x 16mm for 33 cents each from the local hardware store. BTW I didn't have to alter the bulge in the dust shield because the Flywheel was notched for it. A few people locally were asking for the NAPA clutch part no. so here it is MU47620-1C.
RE: Cheap White Bunny Install - whatrwedoingnow - 08-05-2009 06:54 AM
is a z clutch better then a 240 one?
RE: Cheap White Bunny Install - x3whlmotion240 - 08-05-2009 06:07 PM
bigger surface area, I think theres acutally a full write up on nico
RE: Cheap White Bunny Install - 240SXAddict - 08-11-2009 03:23 PM
here's an old write up I did http://www.240sxforums.com/forums/240sx-f-q/90222-ka24e-de-white-bunny-clutch-setup.html